TATA Motors nano emax, Owner'S Manual

Page: 70 / 112

68
INCASE OF EMERGENCY
IF YOU HAVE A FLAT TYRE
Front Jacking Point
Rear Jacking Point
Jacking Points
Remove wheel-mounting bolts and
take out flat tyre and cover (if fitted).
Roll the spare wheel into position and
align the holes in the wheel with
tapered bolts and tighten them as
much as you can by hand.
Lower the jack completely then
tighten the wheel bolts one by one
using wheel spanner. Fit the wheel
cover back (if fitted).
Restore all the tools and jack at it’s
location.
Place the flat tyre at spare wheel
location as described and tighten
properly.
CAUTION
Follow the jacking instructions.
Make sure to set the jack properly
in the jack point. Raising the
vehicle with improperly positioned
will damaged the vehicle or may
cause the personal injury.
Do not carry any other work or
never get under the vehicle
supported by jack.
Do not start or run the vehicle
while supported by jack.
Block the wheel diagonally
opposite to flat tyre being
changed, if necessary.
Do not lift the vehicle with some
one inside.
Raise the vehicle only high
enough to remove and change
the flat tyre.
flat tyre. (Do not remove the flat tyre
at this stage).
Engage the jack properly at correct
jacking point (In between dimple
marks provided at front & rear sides).
Rotate the jack screw in clockwise
direction using wheel spanner to lift
the vehicle till flat tyre is free from
ground.