Tasselli PANDA H205, Use And Maintenance Manual

Page: 10 / 68

10
PANDA
USE AND MAINTENANCE MANUAL
428900224 237
EN
3. DISPOSAL OF WASTE MATERIAL
During normal operation, the appliance does not generate any environmental contamination.
At the end of its life cycle, or if it is necessary to proceed to permanent decommissioning, we
recommend following the procedures below:
DISPOSAL (User)
The symbol, applied to either the product or its packaging, indicates that the product should
not be considered as normal domestic waste, but should be taken to a waste collection point
for the recycling of electrical and electronic appliances. The correct disposal of this product
helps to prevent potential negative consequences that might derive from inadequate product
disposal. For detailed information about recycling this product, contact your council, your
local waste collection service or the store where you purchased the product.
PROCEDURE FOR DISPOSAL and RECYCLING AT THE END OF APPLIANCE LIFE SPAN
(Authorised Bodies)
Foreword
During the period of use, the appliance subject of this manual, is an integral part of a
cooling plant, an electric plant and a hydraulic plant (drain lines). At the end of the life cycle,
the appliance must fi rst be completely disconnected from all plants mentioned above, in
compliance with methods and procedures that are the responsibility of the operator of the
plants and whose description lies outside this manual.
Once disconnected, perform the following procedures:
1. Check that the appliance is disconnected from the electric plant (cables disconnected)
and from the cooling plant (piping cut and opened on the input and output sides).
2. Remove the lamps (if installed). These should be disposed of separately.
3. Remove the power units and the electronic cards. These should be disposed of separately.
4. Remove all the independent parts (grids, casings, profi les, etc.) and group them according
to shared features in order to access the heat exchangers, pipes, cables, etc. and be careful
not to damage the cooling circuit.
5. Remove all mobile parts (doors, sliding doors, glass parts, etc.) and group the various
materials according to their features.
6. Disconnect the evaporator, condenser, compressor, pipes and fans. These are made of
copper, aluminium, steel and plastic and should therefore disposed of separately.
7. On removal of all guards and the various components from the frame, separate the different
types of material making up the appliance (plastic, sheet steel, polyurethane, copper, etc)
and collect them separately.
All recyclable materials and waste should be processed and recycled by professionals, in
compliance with the laws in the country in question.
The company responsible for recycling the materials should be registered and certifi ed as a
waste disposal service in accordance with the country in question
Attention
Illegal disposal of the product by the owner will result in administrative sanctions as required by cur-
rent laws.
Disposal of the product should comply with current laws on the disposal of coolant liquids and mineral
oils.
Important
If the crossed wheelie bin sign is not present on the appliance, it means that the disposal of the
product is not the manufacturer's responsibility. In this case, the Regulations regarding the disposal
of waste in force are valid.
Additional information
Further information on the disposal of liquid coolant, oils and other substances is available on the safety
data sheet corresponding to the substance itself.
In order to dispose of foamed assemblies, remember that the polyurethane foams used are CFC, HFC
and HCFC free.