Fit the small cap screws to the 4
remaining unused base locating
holes (2 on each side).
This is a
required safety step to prevent
these holes.
Step 1 -
Attach the side panels to the base
A).
A
A
B
B
Attach each side panel
to the base. Note the
base position needed for
either ‘cot ’ or ‘bassinet ’
configurations
To secure the base rails:
Insert a lunar washer to the
locating hole at each end
of the base rails and then
insert the connector screws
and lightly hand tighten each
connector screw.
Do not fully tighten the
screws at this time.
Lower Position Assembly
Cap Screw
Higher Position Assembly
4 x lunar washers
M6x15x4
Cap Screw M6x15x4
5
M6 x 50 Bolts x 4
M6 x 15 Cap Screw x 4
the entry of small fingers into
B).IMPORTANT SAFETY STEP