Tasman Networks 1002, Installation Manual

Page: 49 / 78

49
Installation Guide: 1002 and 1004 Routers
TiOS 8.0
Booting From a Network TFTP Server
In the rare and unlikely situation where a software version upgrade fails, a network boot may
be performed as described in the following procedure.
1
Assume that the new T1000.Z download failed when the following command was issued:
This command line is appropriate when the new upgrade T1000.Z file resides on a tftp server
host with IP address 192.168.10.1, in a directory named
software/router .
Upon a download failure (and corruption or deletion of the T1000.Z file in Flash), the Model
1002 and Model 1004 router may not be able to boot.
2
Make note of which Ethernet interface (0 or 1) connects the system to the tftp server
host.
3
Connect a terminal or terminal emulator to the console port of the Tasman Networks
system using the cable supplied. Configure the terminal for 9600 bps, 8 data bits, 1 stop
bit, no parity, and XON/XOFF flow control.
4
Power cycle the Model 1002 and Model 1004.
5
Press and hold the Enter (Return) key while the system boots (usually 10-15 seconds).
6
The following (or similar) text is output to the terminal:
7
Type c , and press the Enter key.
NOTE:
At any point in this procedure, online help can be accessed by typing ? and pressing the Enter
key.
8
If Ethernet 0 is connected to the tftp server host, change fl0 (flash boot) to InPci0.
The following text is output to the terminal:
Router# file download 192.168.10.1 software/router/T1000.Z
Copyright (c) ...
Copyright (c) ...
CPU: Tasman Networks
Variation: 8.3.2
RSP Version 1.1/2
Creation date Sep 8, 2000, 19:14:24
Press any key to stop auto-boot....
1
[Tasman Networks Boot. reboot in 1 minute if CR not pressed]:
[Tasman Networks Boot]:
[Tasman Networks Boot]:
.
.
.
[Tasman Networks Boot]: