Tasman Networks 1002, Installation Manual

Page: 40 / 78

40 CHAPTER 4
Configuration
Default Configuration
Installation Guide: 1002 and 1004 Routers
TiOS 8.0
Default Configuration
For more information about command usage, refer to the appropriate Tasman Networks
Command Reference Guide (either the domestic or international version).
There are three ways to restore factory default configuration settings. Remember to reboot the router
after performing any of the following procedures.
■
Clear the contents of the system.cfg file
clear cfg_file system.cfg
■
Delete the system.cfg file
rm system.cfg
■
Rename and remove the system.cfg file
copy system.cfg system.bk
rm system.cfg
After performing any of the above options, the system.cfg file no longer exists. Subsequently,
a “file not found” error message is displayed upon rebooting the system. This message will not
impact operation, and it should be ignored.
NOTE: If you change any of the factory default settings, issue the save local command to retain the
changed configuration before rebooting.
The following tables show the factory default configuration for the Tasman Networks Model 1002
and Model 1004 router.
Table 8 Ethernet Interface Default Configuration
Parameter Default
speed auto (negotiates 10 Mbps or 100 Mbps)
address uses the current address stored in the system.cfg file (if one exists), otherwise an IP address
must be configured from the command line interface
duplex auto (negotiates half-duplex or full-duplex)
Table 9 IP Default Configuration
Parameter Default
IP routing 1 enabled
IP multiplexing 2 disabled
1, 2 IP routing and IP multiplexing are mutually exclusive of each other. Only one can be enabled at a time.