82
Prior to commissioning
Relocation drive
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Squeegee assembly
Filling the fresh water tank
Dosing
• Switch the machine on (main switch
button with 755B and key switch with
855B).
The display lights up briefly.
The battery level indicator notifies
you that the machine is ready for op
-
eration. (In case of malfunctions,
please see page 88).
• By gently pushing the switch bracket
drive into the direction of movement,
the machine is set into motion. If you
let go of the driving switch, the ma
-
chine will stop.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade
-
quate cleaning results or even floor dam
-
age.
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush will slowly
start to pulse. In this way the tool is
centered and engaged.
The brush drive display lights up.
Notice:
When the brush is down, gently moving
the machine back and forth can make the
clutch easier to engage.
755B
855B
• The machine must be switched off (main switch).
• Position the squeegee (2) below the
squeegee holder (1).
• Press the foot pedal down until the
squeegee holder engages.
• Attach the suction hose to the con
-
nector.
Attention:
Max. permissible water temperature
60 °C/140 °F.
Diversey recommends using cold water
since hot water will adjust to the floor tem
-
perature as soon as it is in contact with the
floor. Thus there are no advantages to us
-
ing hot water.
• The machine must be switched off (main switch).
• Put your hand into the opening be
-
tween tank cover and tank.
Palms upwards.
• Open the tank cover until the support engages in the tank
wall.
• Remove the dosage aid.
• Fill the fresh water tank with water.
Maximum filling level (page 79).
• Tip the tank cover back into its original position and press
it down until it locks.
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han
-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
1
2
2
1
