25
I25
I24
I23
I22
I21
I20
I19
I18
I17
I16
I15
tr
sv
ro
p
t
p
l
n
o
n
l
it
fr
fi
es
en
d
e
cz
Beginning work
With the machine started:
Always turn the keyswitch to the 0-position and remove the key from the
machine if you are going to be out of sight of the machine.
With the machine started:
Cleaning method
Direct method:
Scrubbing and vacuuming in one pass.
Indirect working method:
Apply the cleaning solution (only scrubbing), afterwards scrubbing and
vacuuming.
The cleaning methods are described in detail in the ”Method Card”. You can
obtain this from your TASKI partner.
Refilling the solution tank
The rattling noise from the dosing pump indicates that the solution tank is
empty.
End of operation
Foot pedal
Drain the recovery tank / solution tank
The disposal of the dirty water or the cleaning solution must be carried out in
accordance with the appropriate national regulations.
Recovery tank
Solution tank
Caution:
Always wear non-slip shoes and appropriate work clothing while
working with this machine!
• Lower the squeegee.
• Switch on the keyswitch.
The indicators light up briefly.
• Lower the brush unit using the brush unit pedal, refer to page 24.
• First press the cleaning solution button, and
then the suction unit button.
The indicators light up briefly.
• Choose the volume of solution (+/- button for
cleaning solution dosing control).
The chosen setting is displayed with green
lights.
• By gently pressing the speed control in the
direction of drive, the machine is set in to
motion.
The tools start to turn and the solution is fed
through the centre.
If no operations are carried out on the machine, it will switch itself
off after 5 minutes.
• No manipulations of any kind may be carried out on the brushes.
• the operator must remain within sight of the machine.
• only the squeegee may be cleaned from sucked-in or jammed objects.
• If the J-Fit dosing system has been fitted, the concentrate bag may be
changed or the settings of the J-Fit machine may be modified.
• the operator may only leave the machine for the purposes of clearing the
area to be cleaned, but must remain in visual contact with the machine.
Caution:
Do not clean without solution, as it could cause floor damage.
• Stop cleaning.
• Refill the tank, see page 24.
Start
• Stop the flow of solution.
• Drive a few metres so that the tools rotate further for a short time. You will
avoid dripping by doing this.
Very important when using contact pads!
• To raise the tool, press down the foot pedal and
lock it in place.
• Drive on a few metres further in order to pick up the remaining dirty water.
• Raise the squeegee.
Allow the suction unit to continue running until
the rest of the dirty water has been sucked into
the hose.
• Switch off the suction unit first, and then the
keyswitch.
Always drain and clean the recovery tank every time you use the
machine.
If the dirty water is allowed to stand, unpleasant smells and
deposition of the dirt will take place after a few hours.
• Switch the machine off.
• Take the soiled solution hose from its holder.
(When emptying the tank, always follow the
regulations of the detergent manufacturer
regarding personal protective equipment.)
• Press the neck (1) of the hose together.
• Pull the cover from the hose at the height of the
handle and slowly lower the end of the hose to
drain the recovery tank.
(When emptying the tank, please observe the stipulations of the
manufacturer of the cleaning agent with regard to personal
protective equipment.)
Open the blue cap at the height of the handle and then slowly
lower the end of the hose to drain out the contents.
Start
1
