35
Cleaning the recovery tank and fresh water tank
Caution:
Clogged suction filters may impair the suction per
-
formance.
Cleaning the fresh water tank filter
Caution:
Clean the fresh water tank filter after the end of op
-
eration.
Clogged filters can inhibit the supply of detergents and
thus lead to surface damage.
Notice:
The filter is lower than the drain hole of the tank. A
rest amount of cleaning solution will run out only
when the filter is removed.
Removing and cleaning the brush
Notice:
Clean the brush whenever cleaning work is com
-
pleted.
Single disc Deck:
Double disc Deck:
Roller brush Deck:
Orbital Deck:
Cleaning the machine
Caution:
Never clean the machine with a high-pressure
cleaner or water jet.
Water ingress in the machine may cause considerable
damage to the mechanical or electrical parts.
Storing / parking the machine (not in opera
-
tion)
Caution:
The machine must be switched off. Remove the key.
Notice:
Store the machine with a lifted suction nozzle, lifted
brush and open tank cover.
Thus, the tank can dry, and the generation of mold and
unpleasant odors is prevented.
Caution:
Never store the machine with uncharged batteries.
Otherwise, the batteries will be damaged beyond repair.
• Swivel the folding stand out of the holder and place it into
the tank recess.
• Rinse the recovery tank and the fresh water tank thorough
-
ly with clean water.
• Remove the dirt sieve (yellow), emp
-
ty it and thoroughly rinse it under run
-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, close the red
and blue cover back on and hang the hoses on the holder.
• Reassemble the dirt sieve (yellow) and the suction filter.
• The machine must be switched off (main switch).
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
• Put the filter back and twist it closed.
• The machine must be switched off.
• Rotate the tool counterclockwise
away from the tool connection using
your foot.
• Push the tool ejector briefly but firmly
with your foot.
• Manually remove the orbital pad from
the pad holder.
• Remove the brushes and clean them under running water.
• Wipe the machine with a moist cloth.
1
2
3
