WORKING WITH DETERGENTS —
CONTINUED
Step 4
Turn on the pressure washer. Pull trigger to operate
unit. The liquid detergent will automatically mix with
water and be discharged through nozzle. Apply de-
tergent to a DRY work surface, from bottom to top.
Step 5
Allow detergent to remain on the surface for a short
time before rinsing. Do not allow detergent to dry
on surface.
Step 6
Rinse with clean water under high-pressure. On a
vertical surface, rinse from the bottom up, then rinse
from the top down to avoid streaking. Hold nozzle
6-8 inch from the work surface at a° 45 angle.
Step 7 (End of detergent application)
When you have finished using the detergent injection
system, remove detergent suction tube from bottle
and insert into 5L (1 gallon) of fresh water. Siphon
water at low-pressure for one minute so that all de-
tergent is flushed through system. Remove detergent
bottle and rinse it until it is thoroughly cleaned.
CAUTION
Damage may occur to painted surface if
chemical is allowed to dry on surface. Wash
and rinse a small section at a time. Avoid
working on hot surfaces or in direct sunlight.
CAUTION
Failure to clean properly will cause the
injection system to become clogged
and inoperable.
CAUTION
Never use:
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the surface being cleaned.
10
Summary of Contents for ZE04
Page 20: ...Printed in China ...
