4
ASSEMBLY INSTRUCTIONS
Water Supply (Cold Water Only):
• Do not draw non-water liquids through the unit. For
use with cold water supply only.
• Water hose must be at least a 1/2 inch diameter.
• Flow rate of water supply must not fall below 2
GPM (gallons per minute).
• Flow rate can be determined by running the water
for one minute into an empty 5-gallon container.
• The water supply temperature must not exceed
104°F (40°C).
CAUTION
• Never use the pressure washer to draw
in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
• Dirt in the feed water will damage the unit.
To avoid this risk, we recommend checking
the water filter (located inside the water
inlet; to clean it out see Maintenance sec-
tion on page 11).
• Always prevent debris from being drawn
into the unit by using a clean water source
and an accessory water filter if required.
CAUTION
To prolong the life of the unit, it is recom-
mended to rest the unit 5 minutes after
every 30 minutes of use.
Assembly Time: 5 minutes / Tools Required: Screw Driver
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects which could create a hazard.
Remove any objects from the work area which could be tripped over, such as toys or outdoor furniture.
Ensure that all doors and windows are closed tightly.
Step 1
Attach the left wing (D) and the right wing (J) to the pressure washer unit and tighten the screws to secure
the wings to the main unit.
D
J
Fig. 1
Summary of Contents for ZE04
Page 20: ...Printed in China ...
