©Copyright Task Force Tips, Inc. 2008-2014
LIY-500 May 12, 2014 Rev10
34
4.9.2 ELECTRICAL WIRING
See fi gure 4.0 for typical connections. The 4-conductor cable from the operator station needs to be connected to power (red & black)
and to the communication link (blue & white) from the monitor. Refer to Figure 4.2.2 for typical cable preparation.
4.9.3 OPERATION
Move toggle switch LEFT to rotate (sweep) water
stream from right to left from starting point.
Move toggle switch forward
to move nozzle pattern to
STRAIGHT STREAM.
Y5360
UP
DOWN
STRAIGHT
FOG
LEFT
RIGHT
Read manual before use • www
.tf
t.com
Task F
orce Tips, Inc. 1-800-348-2686
Move toggle switch forward to
move water stream vertically UP
from starting point.
Move toggle switch back to
move nozzle pattern to FOG.
Move toggle switch back to
move water stream vertically
DOWN from starting point.
Move toggle switch RIGHT to rotate (sweep) water
stream from left to right from starting position.
Fig. 4.9.3
Operator Station Label
4.9 TOGGLE SWITCH
MONITOR OPERATOR
STATION (Y4E-TS)
This operator station allows the monitor to be controlled by
three toggle switches. The installer will need to mount the
operator station and connect the cable to the monitor and
power.
4-1/2"
(114 mm)
2"
(51 mm)
MOUNT ENCLOSURE
WITH (2) 1/4-20 FASTENERS.
TIGHTEN SECURELY.
4.9.1 ENCLOSURE MOUNTING
Select proper operator location. Enclosure is designed to be
surface mounted and the size is 5” x 3 1/8” (127 x 80mm).
Height to top of switches is 3 1/8” (80mm). Refer to Figure
4.9.1 for mounting hole dimensions.
Figure 4.9.1
Toggle Switch Operator Station Hole Dimensions
4.10 MONITOR COMMUNICATION
INTERFACE CONTROL
(Y4E-COMM)
This Communication Interface Control converts discrete input signals into serial communications for controlling the monitor. The
discrete input signals can be from a joystick, toggle switches, relay contacts or Canbus output module. The interface box accepts
+12/24 VDC signals, but can be fi eld changed to accept ground signals. The installer will need to mount the interface box and
connect the cable to the monitor and power.
4.10.1 ENCLOSURE MOUNTING
Select proper enclosure location. Enclosure is designed to be
surface mounted and the size is 5” x 3 1/8” (127 x 80mm). Height
of enclosure is 2 3/8” (60mm). Refer to Figure 4.9.1 for mounting
hole dimensions.
Function
Interface Box
Cable Color
UP
WHITE
DOWN
BLUE
LEFT
YELLOW
RIGHT
BROWN
FOG
GREEN
STREAM
ORANGE
(-) BLACK
BLACK
(+) RED
RED
4.10.2 ELECTRICAL WIRING
See fi gure 4.0 for typical connections. The 4-conductor cable from
the communication interface box needs to be connected to power
(red & black) and to the communication link (blue & white) from the
monitor. Refer to Figure 4.2.2 for typical cable preparation.
See fi gure 4.10.2 for connecting INPUTS cable.
Figure 4.10.2
Communication Interface Wire Color/Function
