TS-304UHF RFID User Manual
UHF RFID User Manual
21
2.6 Other Settings
2.6.1 Set DRM Status
DRM is Dense Reader Mode. When multiple readers work at the same time, the RF signal
transmission will interfere with each other, you can open the DRM mode to reduce the
interference between them.
Operation interface as below (Reader Setup->RF Setup):
Note: If DRM was opened, the sensitivity of the reader will reduce significantly. So users
could start this function according to the actual situation.
2.6.2 Operating Temperature Monitoring
Reader will generate heat under high intensity continuous working. Users can monitor the
internal temperature via the built-in temperature sensor to avoid reader overheating
(Operating temperature over 65
℃
). If it’s too hot, you could stop reading for a while.
Interface of the
Temperature Monitor
as below:
2.6.3 Setting Buzzer Status
Sound of the reader’s working status provided to users through the Buzzer.
Users can turn off the buzzer or set it “beep” after each time reader inventory tag.
You can also set it “beep” afer each time reader identifies a tag. But this will reduce the
efficiency of multi-tag identification.
Operation interface as below:
