TASCAM US-1x2
13
5 – Using the Settings Panel
Settings page
1
Direct Monitor Settings IN 1-2
Set the monitoring signal for the IN1, IN2 and LINE IN L-R
jacks to
“Mono”
or
“Stereo”
.
o
When set to
“Mono”
Stereo signals sent to the computer remain unchanged,
but are output as mono signals from the LINE OUT and
PHONES jacks.
o
When set to
“Stereo”
Stereo signals sent to the computer remain unchanged,
and are output as stereo signals from the LINE OUT and
PHONES jacks.
2
Input Volume
Use this to adjust the monitoring balance between the input
signals from this unit’s input jacks and the output signals
from the computer.
Options
Low
/
Mid
/
High
See “Adjusting the monitoring balance” on page 11 for de-
tails about options.
3
Audio Input ON
Turn input on/off for each input separately.
o
Turn an input on by putting a check in its checkbox. When
an input is on, signals on that channel will be input.
o
Turn an input off by removing the check from its check-
box. When an input is off, signals on that channel will not
be input.
4
Buffer Size item (Windows Only)
Set the size of the buffer used when audio input and output
signals are transferred to and from the computer.
Smaller buffer sizes result in less audio signal delay (latency),
but require high-speed processing by the computer.
If the processing cannot keep up, for example, due to other
system operations, clicking and popping noises might occur
and the audio signal might even drop out.
Increasing the buffer size will stabilize operation and sup-
press negative effects on audio signals, but the delay in audio
signals sent to the computer will increase.
You can adjust the buffer size according to the use condi-
tions.
Options
64, 128, 256, 512, 1024 or 2048 samples
5
Auto Power Save ON
When this setting is on, if operating in standalone mode and
no input signal (above −60 dBFS) has been detected for 30
minutes, the unit will turn itself off (start standby) automati-
cally.
o
Putting a check in the checkbox will turn the automatic
power saving function on so the unit will automatically
turn off (enter standby mode).
o
Removing the check in the checkbox will turn the auto-
matic power saving function off.
