9 – Specifications : Dimensional drawing
TASCAM DM-3200 Owner’s Manual
105
Dimensional drawing
Messages and troubleshooting
This provides an alphabetical list of the messages
that you may see on the DM-3200, which provide
information on the operation that you are performing.
Not all of these messages are error messages.
“Information” messages, i.e. those which pop up
briefly and provide information about a change in
status, etc., are marked with a
●
.
“Confirm” messages, where a response may be nec-
essary (usually confirm with the
ENTER
key or can-
cel with the cursor keys) are marked with a
✔
.
Messages demanding action other than a simple con-
firmation are shown with a (
✖
), but even these do not
necessarily indicate an error.
Figure 9.1: Dimensional drawing
MMv
MMv
MMv
MMv
MMv
MMv
Action
Message
Meaning
●
Already assigned.
The RECORD key has already been assigned to a remote unit.
✖
Automation data and Current Status use
different Fs.
Press ENTER to continue.
The automation data uses a sampling frequency of a different value from the
current sampling frequency.
✖
Automation data and Current Status have
different
timecode types.
Press ENTER to continue.
The automation data uses a timecode of a different frame type from the current
timecode.
●
Automation data was recalled.
The selected automation data has been recalled into memory.
●
Automation data was stored.
The current automation data has been stored to card.
✔
AUX 1-2 Level
Set up Ch parameters?
Press ENTER to confirm,
or a cursor key to cancel
Used when batch copying parameters from channel to Aux 1-2 settings.
Table 9.2: Popup messages
