1- Introduction
TASCAM CC-222MKIII
When dubbing from tape to disc, follow the instructions
here.
1 Load the tape with the side that will be recorded
first to be played first. Set the noise reduction,
reverse mode, etc. Also, check the
MONITOR
is
set
DISC
.
2 Load a recordable disc.
3 Use the
MENU
key until
DUB>VOL
appears on
the screen. Use the
MULTI DIAL
to select
THRU
to
bypass the input level control (see
“B
ypassing the
input level for dubbing” on page 23).
If you want to adjust the input volume, set the
DUB>VOL
menu to
ON
and use the CD deck’s
INPUT
control to adjust the level of signals. If
you wish to adjust the volume before recording
starts, put the CD-RW into record standby or
Monitor mode (see
“
Input monitoring on page
20”) and use the
INPUT 1 SEL
key to select
TAPe
.
4 Press the
DUB 1
key.
The CD goes into record standby. The tape re-
winds to the start of the tape and starts playing
back. The CD recorder starts recording.
5 When the available recording time on the disc is
finished, or the tape has stopped, then recording
will stop on the disc.
You can also stop the dubbing process by press-
ing either of the
STOP
keys.
NOTE
A recordable disc must be loaded in the drive. The
DUB 1 key is disabled if the media are not loaded,
and if the drives are in any mode other than stop.
Dubbing to CD from the middle of the
tape
1 To record from the middle of the tape, set noise
reduction, reverse mode, etc. and locate the tape
to the position where playback will start.
2 Press the tape
PAUSE
key to leave the tape in
paused mode.
3 With a recordable disc in the drive, press the
DUB 1
key. The tape will start playing back, and
the disc will start recording.
Recording stops under the same circumstances
as for the whole tape (end of tape, end of disc or
either
STOP
key pressed).
Dubbing from tape to disc
5- Recording CDs
Recording CDs
Bypassing the INPUT level for dubbing
The input control can be bypassed so that it has no
effect when dubbing, in the following way:
1 Press the menu key until the
DUB>VOL
item ap-
pears.
2 Turn the dial to select
THRU
, the control is by-
passed and disabled.
NOTE
This setting applies only to dubbing procedures,
not to other recordings.
It is not possible to make this menu setting (or other
menu settings) when dubbing is actually taking
place.
”Manually divide track” on page 25). If you want to
use manual track division, use the normal recording
procedure, with the phono inputs selected as the
source.
This mode cannot be entered if a recordable disc is
not loaded in the drive.
It is also possible to perform manual recording to disc
from the
RIAA PHONO INPUT
source. This is the same
as the standard manual recording procedure (“Basic
recording” on page 21), except that the
PhONO
input
option should be selected using the
INPUT 1 SEL
key
before recording starts.
