Tartan 3400, Owner'S Manual, Page: 8 / 75

master OM Tartan 3400 2012.doc
Page 8 of 69
 With rigging adjustments completed, install all cotter pins in the turnbuckle threads and re-check
that all cotters are in clevis pins and opened to 20
°
. Tape all cotter pins and unfair edges.
 Install boom and rig mainsheet and topping lift. Check operation of the boom outhaul.
 Connect mast wiring to terminals inside vessel and check operation of mast lights and electronics.
After Launching:
 Check bilge for water.
 Check that engine exhaust is pumping water.
 Verify operation of forward, neutral and reverse before leaving the dock.
To Be Done Prior to Turning Vessel Over to Owner:
 Clean entire deck, including removing excess bedding compound from around fittings, which
may continue to ooze for a short time after shipment.
 Check for deck leaks caused by shipping. NOTE: all boats are thoroughly checked prior to
shipment, but fittings can loosen under shipment and handling.

Touch up exterior teak finish if applicable.
 Inspect and tighten engine shifter and throttle controls as needed.
 Fill water tank(s) and check operation of water system for leaks as well as the hot water if
included.
 Check head operation, holding tank and macerator pump. Operate bilge pump(s). NOTE: if auto
pump is installed, adjust switch level and ensure the auto switch is not blocked by bilge hoses.
Operate sump pump, shower and drain collection, and on some models sinks.
 Check operation of all running lights.
 All fluid levels in engine are to be checked after test run.
 All gauges should be operational.
 Operate galley stove and oven (every burner).
 Adjust lifelines so they are taut.
 Remove all traces of shipping tape.
 Operate all winches and lubricate if necessary.
 Check operation of all thru-hull fittings.