Tartan 3400, Owner'S Manual, Page: 68 / 75

master OM Tartan 3400 2012.doc
Page 68 of 69
To Be Done Prior to Turning Vessel Over to Owner:

Clean entire deck, including removing excess bedding compound from around fittings which
may continue to ooze for a short time after shipment.

Check for deck leaks caused by shipping. NOTE: all boats are thoroughly checked prior to
shipment, but fittings can loosen under shipment and handling.

Fill water tank(s) and check operation of water system for leaks as well as the hot water if
included.

Check head operation, holding tank and macerator pump. Operate bilge pump(s). NOTE: if
auto pump is installed, adjust switch level and assure that auto switch is not blocked by bilge
hoses. Operate sump pump, shower and drain collection, and on some models sinks.

Check operation of all running lights.

Run engine in gear for a minimum of one hour.

All fluid levels in engine are to be checked after test run.

All gauges should be operational.

Operate galley stove and oven (every burner).

Interior teak oiling to be touched up as needed. We recommend Watco Teak Oil. (Oiled
Teak interiors only)

Adjust lifelines so they are taut.

Remove all traces of shipping tape.

Operate all winches and lubricate if necessary.

Check operation of all thru-hull fittings.

Operate all hatches and ensure that no binding occurs.