Target PORTA-TILE II, Operating Instructions And Parts List Manual

Page: 16 / 34

16
The manufacturer accepts no
responsibility caused by unsuitable
use or modifications.
13 TILE CUTTING ACCESSORIES
The instructions for use and spare parts found in this document are for information
only and are not binding. As part of our product quality improvement policy, we
reserve the right to make any and all technical modifications without prior notice.
Dual 45 degree Adjustable Bullnose Mighty Miter Guide Folding Stand
Angle Guide Protractor Miter Guide
Parts List:
Diag. Part No. Qty. Description Diag. Part No. Qty. Description
1 051020 1 Angle Guide Assy, Dual 45
°
7 050105 1 Clip, Stop
2 189737 1 Knob, 1/4"-20 x 1" 8 050106 1 Spring
3 051010 1 Protractor Assy, Adjustable 9 050107 1 Bar, Locking
4 051030 1 Miter Guide Assy, Bullnose 10 050103 1 Knob
5 050102 1 Miter Guide Assy, Mitghty 11 051041 1 Folding Stand, Tile Saw
6 050104 1 Frame, Miter
RIP GUIDE : P/N 051000 - The Rip Guide is a standard ac-
cessory supplied with every tile saw. It is used to
provide a repeatable position for rip cuts until relocated.
The Rip Guide clamps to the machined backstop of the
conveyor cart.
ANGLE GUIDE : P/N 051020 - This is a non-adjustable mi-
ter used to quickly position the tile at 45 degrees; either
on the left or right side. It is often used for repeated
diagonal rip cuts. The Angle Guide clamps to the back-
stop.
ADJUSTABLE PROTRACTOR: P/N 051010 - The
Protractor can be used to rip cut known angles. The
protractor clamps to the backstop.
BULLNOSE MITER GUIDE: P/N 051030 -This is a fixed
guide that positions the tile for a 45 degree miter cut.
The Mitering Guide clamps to the backstop.
MIGHTY MITER GUIDE: P/N 161480 - This is a 45 degree
fixture that has an adjustable clamp to hold the tile while
miter cutting. The Mitering Guide clamps to the back-
stop.
FOLDING STAND: P/N 051041 - This stable, one piece stand
brings a TARGET® tile saw to standing level for ease of
work. The stand conveniently folds flat for storage and
transporting.
FENCE-PRO: P/N189546 -This accessory holds the tile in
place while cutting or profiling. 1/4” increment marks
asist with slightly out of square cuts. The Fence-Pro
clamps to the bottom of the backstop with two thumb
screws. (Not Shown)