Tarana G1 RN, Manual

Page: 3 / 16

Tarana Wireless, Inc. Proprietary and ©2021. All rights reserved. vG1-RN-2021-01 G1 RN Manual — 2
Safety and Warnings
Tarana G1 equipment is designed for installation and use by trained professionals
and requires adherence to all relevant regulatory, safety, and telecom industry best
practice guidelines for outdoor radios.
General Warnings
Failure to observe these safety precautions may result in personal injury or damage
to equipment.
• Follow all warnings and instructions marked on this product.
•
Use standard safety guidelines when mounting. Installation and
maintenance procedures must be followed and performed by trained
personnel only.
•
Before unmounting the product, disconnect power input to reduce the risk
of hazards.
•
Do not exceed 60 VDC of input to the device.
• Do not open the device. Opening the device voids the warranty.
•
Do not stack anything on the radome.
• Dust covers must be installed on all connectors when not in use.
•
Cable ends must be protected from weather if not connected to the device.
• When the SPF+ port is used, this is a Class 1 laser product. Invisible laser
radiation can be emitted from the aperture of the port when no fiber is
connected; therefore, avoid exposure to laser radiation and do not stare
into open apertures.
FCC Information
The FCC occupational controlled limit for maximum permissible exposure (MPE) is 5
mW/cm2. It is estimated that the maximum power density at the radome is 1.25
mW/cm2, which is below the FCC MPE limit. Since the power density for an
occupational controlled environment is less than the FCC limit, no additional
precautions are necessary. The occupational uncontrolled environment limit for
maximum permissible exposure (MPE) is 1 mW/cm2. To meet this MPE requirement,
the operator must be at a distance of 7.87 in or 20 cm away from the radome cover
of the system.
General Health and Safety Information
Topic Explanation
Flammability
The equipment is designed and constructed to
minimize the risk of smoke and fumes during a fire.
Hazardous Materials
No hazardous materials are used in the
construction of this equipment.
Hazardous Voltage
The G1 system meets global product safety
requirements for safety extra-low voltage (SELV)
rated equipment.
Safety Signs
External warning signs or other indicators on the
equipment are not required.
Surface Temperatures
The external equipment surfaces become warm
during operation, due to heat dissipation. However,
the temperatures reached are not considered
hazardous.