Tarana Wireless, Inc. Proprietary and ©2021. All rights reserved. vG1-RN-2021-01
G1 RN Manual — 11
Physical Installation
The RN mount is a saddle clamp that is adjustable in azimuth and tilt (20° uptilt – 5°
downtilt supported). In typical installation, the RN is installed on a pole mounted to
the side of a dwelling.
Preparing the RN
Step 1.
Carefully place the RN face down on a surface that will not damage the
plastic radome.
Step 2.
Place the chassis bracket onto the back of the RN and locate it onto the 4
threaded holes.
Step 3.
Using an 8mm hex socket, install the four screws, and gradually torque
them in a crossing pattern to the specified torque value of 6 N-m (4.5 ft-lb)
Step 4.
Partially install one screw on each of the elevation attachment tabs of the
chassis bracket in the locations closest to the top of the RN unit. These two
screws should be threaded into the tabs enough that 2 or 3 threads are
exposed coming out of the backside of each of the tabs.
Summary of Contents for G1 RN
Page 1: ...TaranaG1RNManual ...
