Working
amplifier
Battery with voltage
below 9V
above 17V
Battery with voltage
Temperature above operating
limit (> 85 ° C)
4 - NEGATIVE POWER SUPPLY:
Use a cable of minimum 4 AWG up to maximum of 1/0 AWG as short as possible,
connected to the negative battery pole.
2 - POSITIVE POWER SUPPLY:
Use a minimum 4 AWG up to maximum of 1/0 AWG cable direct from the
positive battery terminal, with fuse or circuit breaker (200A), as close to it as possible.
1 - SMART COOLER:
This amplifier has two internal ventilation fans. For perfect functioning, the amplifier must
be installed in a cool and aired place with at least 1” (25mm) space around the heatsink for proper heat spreading.
The usually working temperature of amplifier is 65°C.
3 - TERMINAL REMOTE:
It must be connected to the remote output of the head unit using a 18 AWG cable.
We recommend that all cables have tinned ends for better electrical contact.
In case of power bus bar using, avoid tightening with extenders on the allen wrench, as excessive torque may
break the the terminal.
11
Power supply connector
LEDS indicators & protection system
Effect bars
with the last
schedule
Effect bars
blink 2x
in red
Effect bars
flash 3x
in red
Effect bars
flashing red
6x per second
continuously
Effect bars
flashing yellow
1sec. lit
1 sec. wiped out
Blue LED on
Red LED
flashes 2x
Red LED
flashes 3x
Red LED
flashing 6x per
second continuously
Yellow LED
flashing 1 sec. on
1 sec. off
ENGLISH
POWER
INPUT
1
1
2
3
4
The fan and ventilation openings are responsible for cooling the amplifier when it is in
use, so it cannot be obstructed.
CAUTION
Before making any connections to the power terminals, make sure that the negative (-)
of the vehicle battery is disconnected.
CAUTION
Conditions
LED of Monitor
RGB LEDs
Short circuit on output or
between output terminal to GND
The thermal protection waits for cooling before restarting.
If it goes into protection, the amplifier will automatically restart.
Example:
Low Battery Protection:
Working amplifier Red LED (LED Monitor) or Smart LEDS, flashes 2x Red LED
(LED monitor) or Effect bars, flashes 2x Amplifier restarts.
