09
Taramps reserves the right to modify the contents of this document at any time without prior notice and does
not have the obligation to apply the changes in units which were previously produced.
As you read this manual, pay attention to the safety symbols.
Safety
This symbol with
“CAUTION”
is intended to alert the user to the presence of
important instructions. Failure to heed the instructions will result in risk of
injury to user or product damage.
CAUTION
Read this manual before preparing the product. In case of
doubt, contact our technical support: (
18) 3266-4050
or
www.taramps.com.br.
At the end of its useful life, this product must not be
disposed of in household waste. Look for an
electronic equipment collection or recycling center
for proper disposal.
Declaration of Conformity
TARAMPS ELECTRONICS LTDA
Alfredo Marcondes - SP
Brazil
Hereby, Taramps Electronics Ltda declares that the product
The Big Boss 3 Bass complies with the Directive 2014/30/EU,
according with the following harmonized standard:
Electromagnetic compatibility (EMC) -
Product family standard for aftermarket
electronic equipment in vehicles
The full text of the EU Declaration of Conformity is available at
the following Product Page on Internet.
-
When in use, the external surface of may amplifier becomes hot. Avoid touching the heatsink
area and keep childrens far from the amplifier.
-
If you want to dispose this amplifier, don't throw it on domestic waste. It must be collected by
an used electronic product disposal service for proper recycling.
To ensure proper use, please read through this manual before using the amplifier. It is
specially important that you know the
CAUTIONS
contained here.
-
This amplifier may produce high sound pressure levels. Avoid continuous exposure to levels
over 85dB to prevent permanent hearing loss.
-
Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect
any wires routed through car's body.
-
This amplifier is for use with 12V batteries. Always check the voltage before installing.
-
Be sure to install protection fuse or a circuit braker near to battery. Follow the ampere rating
as indicated here in this manual. Use of improper fuse or circuit breaker could result in
overheat, smoke, damage to product, injury or burns.
-
Before make any connection to amplifier, disconnect the battery negative terminal.
-
Never install the amplifier in places exposed to dust, humidity and water. Pay attention to
install it far from fuel tank, fuel lines, heat sources and other parts of vehicle.
-
Output connections for speakers may have voltage levels when the amplifier is operating.
Make sure that the amplifier is turned OFF before proceed any connection or disconnection in
this terminals.
-
This amplifier must be installed in a firm place with at least 1” space around the heatsink for
proper heat spreading.
-
The installation of this amplifier must be done by a qualified professional.
-
Wear safety glasses, insulated gloves and correct tools for installing this product.
Safety requirements
Introduction
-EN 50498:2010
