Battery recharges and amplifier powering
The Intelligent Charging System analyzes and monitors battery status and amplifier
power/consumption.
In this case, in addition to recharging the batteries, the
PRO CHARGER 90A
power supply acts
as an auxiliary to the batteries in powering the amplifiers.
The power supply can be used to recharge various types of 12V battery capacities. For the PRO
CHARGER 90A version, the best performance is obtained for recharging batteries (or battery
bank) between 60Ah and 1300Ah nominal capacity.
The power supply's SMART functions aim to optimize battery recharging by applying slow
charging when needed and automatically switching between charge, float, and battery
equalization modes. In addition, the power supply constantly monitors its output and
identifies when an amplifier is consuming a high load, thus requiring the maximum power of
the power supply.
12
LED indicators & protection system
LEDs flashing 3x
LEDs Flashing 2x
LEDs flashing 6x per second
and continuously
LEDs flashing, 1 second on and
1 second off
3x
2x
6x
High temperature protection actuation. The power
supply shuts off the output and waits for the
internal temperature to decrease.
Short circuit detected at the power supply output.
The power supply automatically check the output
every 5 seconds.
Critical battery level detected (<6V) connected to
the power supply output.
Battery at high level detected (>16V) connected to
the power supply output.
Conditions
ILLUMINATED LOGO:
Lights up when the power supply is on and informs when the protections are
activated:
Smart LEDs
When blinking fast, batteries are recharging , and when this led is on the
batteries recharge is completed.
LED FULL POWER:
Is on when in power supply mode, or when is recharging
and identifies the need of full power on this output.
If the LED is blinking slowly, the battery has been disconnected or the health of the battery may
be compromised.
LED SMART MODE:
Show that the power supply is in SMART MODE.
