6-CLEANING AND MAINTENANCE
Before cleaning or servicing the mistblower make sure engine is stopped and cooled.
6.1- AIR CLEANER
Before servicing your mistblower,apply the safety regulations indicated in paragraph 1.
1.Remove air cleaner of the engine,clean and dry thoroughly and install it back (Fig: 16-17-18)
2.Lubricate the gasket on the chemical tank cover occasionally.
3.The consumer will carry all responsibilities resulting from not using original spare parts.
4.Wash and clean your mistblower after each use with clean water.
5.Do not leave any chemicals in the chemical tank.
6.If the air cleaner is torn, or becomes smaller change it with a new one.
Þekil.11
(Figure.11)
Þekil.12
(Figure.12)
Þekil.13
(Figure.13)
6.2-YAKIT FÝLTRESÝ
Motorunuz çalýþmadýðýnda yakýt gurubunun ve yakýt filtrenizin týkalý olup olmadýðýný kontrol
edin (Þekil. 14).
6.2-FUEL FILTER
If the engine does not start, check the fuel filter and the fuel system around for any blockages.
(Fig:14)
6.3-BUJÝ
Buji týrnak aralýðý 0,6 - 0,7 mm olmalýdýr. (Þek.15) Buji týrnak aralýðý zamanla karbon yada kurum kaplayacaðýndan bujinizi
kontrol edip, temizleyin. (Þek.15) Buji týrnaðýnda oluþan karbon yada kurum motorunuzun performansýnýn düþmesine yol
açabilir.
6.3-SPARK PLUG
The spark plug end clearance should be around 0,6 to 0,7mm.(Fig:15)
Since the end will be covered either carbon or other deposists, check the
spark plug and clean with suitable brush.The carbon formation and deposits
at the spark plugs can degrade the efficiency of the spark plugs.
7-DEPOLAMA
1.Aleti kullanýmdan sonra temiz su ile yýkayarak temizleyin.
2. Ýlaç deposunda ilaç býrakmayýn.
3.Yakýt deposunda kalan benzini temiz bir kaba koyun ve motoru duruncaya kadar çalýþtýrýn. Aksi halde benzin buharlaþýr
ve içinde karbüratör memelerini týkayabilir.
4.Bujiyi çýkartýn, silindirin içine pas önleyici veya motor yaðý koyun, kranký birkaç kez döndürerek karýþýmýn daðýlmasýný
saðlayýn. Bujiyi tekrar yerine takýn.
5.Tekrar kullanacaðýnýz zaman bujiyi çýkartýn ve temizleyin. Kranký bir kaç kez döndürün.
7-STORAGE
1. After every use of machine clean the chemical tank with water.
2.Do not leave chemical in the tank.
3.Empty the fuel tank and run the engine until fuel finish inside the carburetor. Otherwise gasoline will be vaporized and
clog the carburator orifices.
4.Take the spark plug out and pour corrosion inhibitor or thin engine oil into the cylinder.Revolve the crankshaft for a few
times to make the mixture to disperse.
5.Before using the device again,take out spark plug and clean it.Revolve the crankshaft a few
times.
(12)
Þekil.14
(Figure.14)
Þekil.15(Figure.15)
