Tar River PTS-100, Operator'S Manual

Page: 19 / 32

19
Fertilizer Spreader PTS - 100, PTS - 160 Series
Maintenance
•
Proper maintenance is the responsibility of the owner/operator. Poor maintenance is an invitation to trouble.
•
Operate the spreader in an area with adequate ventilation. Never operate the engine of
the towing vehicle in a closed building. Exhaust fumes may cause asphyxiation
(suffocation) leading to serious injury or death.
•
maintenance.
•
Always use the proper tools or equipment for the job at hand. Maintenance area should be clean and dry.
Electrical outlets and tools are to be properly grounded.
•
Use extreme caution when making adjustments. Securely block equipment before servicing.
•
After servicing, be sure all tools, parts and service equipment are removed.
•
Use personal protection equipment (PPE) such as eye, hand, hearing and proper mask to filter any chemi-
cals used.
•
Check tightness of all hardware periodically, including; bolts, nuts, screws, pins. See page 21 For torque
specifications.
•
Inspect tires for damage, wear and tear, and pressure. Add the proper amount of air according to the tire
manufacturers specifications. Pressure specifications can be found on the tire.
•
Use caution when inflating or servicing tires. Tires can be extremely dangerous if mishandled. Call on
trained professions to service the tires if necessary.
•
Where replacement parts are necessary for periodic maintenance and servicing, genuine factory replace-
ment parts must be used to restore your equipment to original specifications. The manufacturer will not
claim responsibility for use of unapproved parts and/or accessories and other damages as a result of their
use.
•
liability
for injury or warranty.
Service
Before operating spreader:
•
Grease all exposed moving parts.
•
Check air pressure in tires.
•
Check all hardware for tightness.
•
Replace worn or damaged parts.
Danger: Never attempt to perform maintenance on the machine without first stop-
ping the towing vehicle
’ s engine, setting the parking brake and removing the key
from the ignition. Always wear the proper protection (PPE) when performing ser-
vice. Refer to the chemical manufacturer for proper safety recommendations.