5
805-0039 Rev F
F.
Slide Flow Control Module/Mechanical Module (FCM/MM) onto base plate and
verify that the two bosses on the plate are lined up. Secure the manifold to the
base plate with the two thumb screws.
G.To install the holster use the screws provided. Install the holster and drain assembly
in close proximity to the bar gun location. Holster mounting plate must be
placed so that the release tab is accessible. Plumb the
holster using 1/2”
standard drain hose and follow local plumbing codes. Refer to the cleaning and
maintenance section for proper removal and cleaning of holster.
Release Tab
Fig. 5
SETTING RATIO
The Bar Dispenser has been thoroughly tested and sanitized prior to shipment. The installer
will be required to set the ratio of the bar dispenser.
A.
Rotate the yellow shut-off stem to the
“on”
position (
Fig. 4
).
B.
To adjust water flow rate, press plain water button or carbonated water button on
bar dispenser and capture water in a graduated cylinder or ratio cup, while timing
the dispense. Divide the volume of water dispensed by the time. This will equal the
flow rate in oz/s
C.
To adjust the flow, turn the red adjustment screw (
Fig 6
). To regulate a ceramic
FCM, turn clockwise to increase flow and counterclockwise to decrease flow. If
the flow control assembly contains a green adjustment screw it is a MM. To
regulate flow, turn counterclockwise to increase flow and clockwise to decrease
flow (opposite of ceramic flow control) (
Fig. 7
)
IMPORTANT
NEVER PLACE THE HOLSTER DIRECTLY OVER THE ICE BIN. HOLSTER INSERT CAN BE
REMOVED AND USED WITH OTHER BAR DISPENSER HOLSTERS.
INSTALLER TIP:
Place your bar dispenser as close as possible to the product cooling source to minimize the
dispensing of warm product and reduce foaming of the finished drinks.
INSTALLER TIP:
Installer must cool or chill the product before setting the ratio of
the system. Ratio will be different in cold product and warm product.
IMPORTANT
BEFORE SETTING RATIO, PURGE PRODUCT AND WATER THROUGH
BAR DISPENSER TO ENSURE PROPER PRODUCT TEMPERATURE.
Summary of Contents for Rattler II
