TAPEPRO CORNER BOX
The Tapepro Corner Box is designed to be used with the Tapepro Corner Finisher or Corner
Glazer to apply a finishing coat to all 90º internal angles. This is one of the last procedures
and will cover the tape with joint compound and feathering the compound onto the
plasterboard.
BEFORE USE
USING THE TAPEPRO CORNER BOX
> Ensure that the Tapepro Corner Box is free from any dry joint compound.
(CB-1)
> Check that both the pressure plate and the filler valve move freely.
1.
Fill the Tapepro Corner Box by removing the nozzle from the box
filler which is attached to the loading pump. Insert the Tapepro
Corner Box filler valve into the box filler.
(CB-2)
2.
Pump until the box is full.
3.
Snap the Tapepro Corner Finisher or Corner Glazer onto the nose
cone of the Tapepro Corner Box. When using a Corner Finisher,
ensure the swivel chain is attached, to reduce the risk of damage.
(CB-3)
4.
Place the Tapepro Corner Finisher or Corner Glazer at the top
of the internal. Apply pressure and pull the Tapepro Corner Box
down the internal to approximately 600mm from the bottom of
the joint.
(CB-4 & CB-5)
5.
Turn the Tapepro Corner Box around and starting from the
bottom of the joint run up the internal.
(CB-6)
CB-1
CB-2
CB-3
Summary of Contents for CORNER BOX
Page 1: ...TAPEPRO CORNER BOX...
