15
Leg Tubes
Mounting
Plate
U Clamp
Mounting
Plate
Channel
Leg
Plate
36
1
/
2
"
36
1
/
2
"
Center of
Bender
3
Set legs onto Bender with leg tubes near drilled
pilot holes. Place “U” clamps over leg tubes, align
holes and install sheet metal screws. Drill re-
maining holes through clamps and install screws.
Install screws also in mounting plates as shown.
1
Position leg plates into
mounting plate channels,
align holes and install
nuts and bolts provided.
36
1
/
2
"
36
1
/
2
"
Drill
Drill
Drill
Drill
U Clamp
Mounting
Plate
Center of Bender
➤
2
Invert Bender. From center of Bender,
measure outward along each rail
36
1
/
2
" and drill one pilot hole in center
of each rail using an 11/64" drill bit.
Installing the Light Duty Folding Legs
OPTIONAL PRO-STAND & LIGHT DUTY LEGS SET UP
Steps
(indicated above)
1. Remove all parts from box. Attach 2 x 4 Bracket to Vertical
Support using 1/4-20 x 1 1/2" Hex Bolt and 1/4-20 2-Way Lock
Nut.
2. Slide Vertical Support into End Assemblies, setting to desired
height, and secure with Faspin (part #10678).
3. Attach Wheel Assembly to End Assembly using 1/4-20 x
2 1/2" Hex Cap Bolt and 1/4-20 Two Way Lock Nut.
4. Fold wheels to pad position (as indicated in diagram) and
stand End Assemblies apart.
5. Attach both Cross Braces by seating pins into center holes in
legs and tightening the “T” Knobs into the top threaded holes
(see Detail A above).
6. Assemble Brake Brackets (see Detail B) securing with hex
nuts. Repeat for other Bracket.
7. From bottom of Bender, align holes in Brake Brackets with
holes in Front and Back Rails of Bender. Insert washer head
screws and tighten Brake Brackets in place.
(*Pre '99 Benders
will need to be drilled)
8
. Turn Bender right side up and fit Brake Brackets into 2x4 brack-
ets. Align holes in Brackets and insert Faspins. After the Brake
Brackets are installed on the Port-O-Bender, entire unit can
be quickly detached from Pro-Stand by removing Faspins.
Pro-Stand Setup
Instructions
Rail
PRO 2000
PRO III
Only
FRONT OF
BENDER
DETAIL
B
DETAIL
A
Cross Brace
Detail
