3
TapcoTools.com
800.521.8486
1
Remove Locking Handle and
Handle Grip from parts bag. Press
Grip over end of Locking Handle and
slide down until Grip is firmly seated.
Remove rest of parts from bag and
proceed to next step.
2
Insert bottom end of Locking
Handle into the bottom Yoke on right
side of Port-O-Brake.
®
Align holes
and insert Yoke Pin. Align top hole in
Handle with holes in Locking Block of
Slide Bar and insert second Yoke Pin.
3
Insert Cotter Pins through holes in
ends of both Yoke Pins. Bend one leg
of each cotter pin forward to secure
Yoke Pin.
1
Insert the ends of the Lifting
Handle/Handle Plug Assembly up
through the holes in the bottom of
the Moving Hinge. Align holes in the
Handle Plugs with the holes located in
the face of the Moving Hinge.
2
With holes aligned, insert screws
through Moving Hinge and into
Handle Plugs. Place washers over
ends of screws in back and tighten
with hex nuts. Handle can now be de-
tached from Handle Plugs by remov-
ing Faspins.
FACE OF
MOVING HINGE
ALIGN HOLES
AND INSERT
SCREWS
FASPIN
SCREW
FASPIN
LIFTING
HANDLE/
HANDLE PLUG
ASSEMBLY
MOVING HINGE
WASHER
HEX NUT
HANDLE PLUGS
BEND ONE LEG OF COTTER PIN
OUT AFTER PASSING THROUGH
YOKE PIN
Setup Instructions
COTTER PIN
Attaching the Locking Handle
Setting Up the Lifting Handle
YOKE PINS
LOCKING
HANDLE
YOKE
LOCKING
BLOCK
