IG-21-8-020-A
Suction Cup Mount Installation
Using the mounting plate as guide on the mounting
surface, align to the desired location of the antenna.
Press firmly on each cup to secure in place
Note: Check that the surface to mount on is flat,
non-porous, and has been adequately cleaned to ensure
proper adhesion.
Insert the rubber (both top and bottom) through the
inner slots of the mounting plate
Insert the ball joint firmly into the socket on the back of
the antenna body and slide the tightening nut into the
antenna housing’s back plate to secure in place. Adjust
to the desired antenna orientation on the bal joint and
tighten the nut to fix the antenna in place.
Insert the tightening nut onto the ball joint mount with
the flat surface facing away from the mounting plate
Installation Completed
Waiver:
This document represents information compiled by Taoglas to the best of our current knowledge. This is not intended to be used as a
representation or warranty of fitness of the products described for any particular purpose. This document details guidelines for general information
purposes only. When planning installations, always seek specialist advice and ensure that the products are always installed by a properly qualified
installer in accordance with applicable regional laws and regulations.
