D.
SAFETY INSTRUCTIONS
Before using this product, please read this manual and follow all safety rules and operating
instructions. Failure to comply with instructions could result in personal injury and/or property
damage.
The manufacturer is not able to predict all possible dangers caused by this product during
operating, checking and maintaining. Thus, not all possible dangers are listed in this manual.
Any condition not shown in this manual is still needed to be careful watch during operating,
checking and maintaining. Please contact your supplier for any further information.
The manual is considered as part of the machine and must be kept in a safe place for future
reference, enabling quick consultation.
1. If any malfunctions happen, stop using this machine immediately.
2. Do not use this machine under rain or thunder. There will be the risk of fire or electrical
shock.
3. Be sure the electrical plug is removed from the electrical socket before attempting any
cleaning or maintenance. Fail to do so may cause electric shock.
4. If any important part gets damaged, stop using this machine immediately.
5. The cleaner or electrified circuit, including every installation, cable and electric socket
should not be spilled with water. Keep the plug and wire dry and clean and do not touch
it with wet hands. Carefully remove the plug from the electric socket and do not pull the
wire emphatically.
6. Be sure this machine is on a stable, flat surface and the brake of the wheel must be
turned on when in operation. Set the machine with good ventilation when in operation.
7. Children or non-staff are prohibited to operate this cleaner.
8. Do not trample, pull wires or high pressure hose or place objects upon them.
9. All parts are designed for high pressure. If any part gets damaged, please replace it with
the parts from original manufacturer.
1. Ensure enough oil is filled into the pump before operation.
2. Comply with the specified voltage, current, frequency and phase labeled on the
specification plate.
3. Please run this cleaner with the pressure lower than the maximum pressure of the
specification. Do not exceed the limit.
