02_ OCV OWNER MANUAL
contents
INTRODUCTION
02
WIRInG & settInG UP
06
UnPAcKInG
02
DIMensIons
07
sAFetY notIces
02
tecHnIcAL sPecIFIcAtIons
08
PRoDUct FeAtURe IDentIFIcAtIon
03
WARRAntY
09
AccessoRIes
04
DecLARAtIon oF conFoRMItY 10
InstALLAtIon GUIDe
05
IntRoDUctIon
Thank you for purchasing this Tannoy Product loudspeaker.This product range is suited for high-level music and
speech reinforcement applications requiring exceptional sonic quality with uncompromised reliability.
UnPAcKInG
Every Tannoy product and accessory is carefully inspected before packing. After unpacking, please inspect your
product to make sure no damage has occurred in transit. In the unlikely event of any damage, would you please
notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return the faulty unit to
them for inspection.
Each OCV loudspeaker is provided with the following accessories as standard; Gripple speed clamps, release key,
1 x hanging cable, 1 x safety cable, 1 x terminal weather boot, 1 x euroblock connector, 3/8” screwed rod adaptor,
cable ties.
sAFetY notIces
some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to
provide security of a backup support. A secondary support line should be attached from the safety loop on the rear of
the product to a source point on the ceiling. Please consult the relevant construction codes in your region.
Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers.
sAFETY NOTE:
In order to comply with the relevant fire safety regulations (ie. BS 5839:1998), it is required that in the event of fire,
that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is
complete. suitable measures include: -
a) use of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example
constructed from ceramic materials;
b) use of terminal blocks of a lower melting point but protected with thermal insulation;
c) use of terminal blocks such that, on melting, an open-circuit or a short-circuit does not occur.
Series
