www.tanningessentials.co
TOWER ASSEMBLY
STEP 7
Locate the foot pedal and power cord. Connect the
power cord to the shorter cord coming out of the foot
pedal. Connect one of the longer cords from the foot
pedal into the base of the station, this is your spray
machine. Connect the other longer cord from the foot
pedal into the bottom fan unit of the tower. Find one of
the connector cords and insert the metal male end into
the bottom fan unit, and the female end into the middle
fan unit. Find the second connector cord and insert the
metal male end into the middle fan unit, and the female
end into the top fan unit. Plug the power cord coming out
of the foot pedal into the wall socket.
STEP 5
Locate the aluminium sides and peel off the protective
film. Insert the aluminium sides in between the fan units
and the loosely screwed-on metal support bars. Once
the side panels are inserted, starting from the top, tighten
the screws to clamp the side panels tightly into position.
(Note: these are reversible for two colour options)
STEP 6
Attach the spray applicator holder. Gently slide the inner
rubber out, ensuring it stays attached to the plastic at all
times. Turn the cup upside down, with the opening of the
rubber facing towards the edge. Fit the rubber onto the
edge of the side panel, as far as it can go. While holding
the rubber in place, swing the cup upwards on its hinge
and slide over the rubber.
