www.tanningessentials.co
TOWER ASSEMBLY
STEP 1
Lay the floor into position, the wide straight edge is the front.
STEP 2
Using the handle, place the base unit on the back of the floor
with the hollow side facing down.
STEP 3
Locate your three fan units, picking them up with the handles
located on the back, place the first fan unit onto the base,
lining it up with the grooves – make sure it is securely in place
with no movement.
Stack the next fan unit on top of the first one. And the third fan
unit on top of the second one so you have a total of three fan
units on top of the base. Ensure the red filter release buttons
are on the right hand side when looking at the front of the station.
STEP 4
Locate the metal bars and base seals to align them with the
holes on the top of the base station, ensuring the seals with
washers are positioned between the base and bars with the
washers on top. Loosely screw the metal bars to the base
unit and the fans using the screws provided, allowing room to
insert the sides and only tighten after the sides are in place.
