15
1
LED
decorative
light
Turn on the decorative light to activate the atmosphere, and place in the glowing center
of the light a little essence, which will give off charming aroma after heating.
2
Decorative
light
switch
Press the switch to turn on/off while the decorative light is on.
3
Power LED
The Power LED will light when the Docking Station is connected with the power, or
turn off if not connected.
4
Charging indicator
The indicator will flicker while the recharger is connected with the cleaner.
5
Signal transmitting
Transmitting signal is the only way to lead the cleaner to return the Docking Station for
charging, so the signal transmitting position should be clean for long without any
obstacle on it.
6
、
7 Recharging positive
& negative electrode
The electrode and that of the Cleaner are connected to charge under contact mode, so
the position should be clean without any obstacle on it while using, or there will be
impact to the charging.
8
Charging power DC
socket
The power DC socket, called recharger for short, used to connect output terminal
DC24V of the adaptor, is the charging transit station between the Cleaner and adaptor,
so the recharger should be placed against the wall firmly and the adaptor cable should
be away from the recharger, or the Robot may have impact and winding during
cleaning.
:
Some essence may damage the plastic surface, so please make purchase and use after consideration.
Installation of Auto Charging Docking Station and Charging for the cleaner
Automatic recharging:
1.
Install the Docking Station on the flat ground firmly and
against the vertical wall.
2.
No obstacle or hollow areas 3m away from the Docking
Station in the front and 0.5m on the right and left. (Refer to
Figure 1)
3.
The Cleaner cannot search the Docking Station for charging
if the infrared signal transmitting window of the recharger is
covered.
4.
Connect the output terminal of the adaptor with DC socket of
the Docking Station. (Refer to Figure 2)
: Please put the power cord of the adaptor in order and place
it along the wall, or it may affect the automatic recharging.
Manual charging:
1.
You can use the adaptor or Docking Station of the
Cleaner to charge for the main body directly.
2.
Connect the output terminal of the adaptor with
DC socket of the main body while using the
adapter for charging. (Refer to)
0.5m
0.5m
3m
Figure 1
High Voltage! Electrical
hazard! Please dry your
hands before using!
Figure
2
