ripple
ripple
ripple
ripple
User
User
User
User
Manual v1
Manual v1
Manual v1
Manual v1
rev
rev
rev
rev2
2
2
2
8
8
8
8
Make sure the USB cable is connected properly. Also make sure the USB port on your
computer can supply the 500mA the panel requires. Some laptops do not allow this.
See the section “USB hubs and extenders (or repeaters)”
If the panel still doesn’t work after checking the above then contact Tangent support.
12.
Care of your panel
Your panel should not be cleaned with harsh abrasives or chemical cleaning products. If
they become dirty wipe them with a soft damp cloth.
Sharp objects, such as watch straps and jewellery, will scratch the plastic so be careful
not to bring such items in to contact with the panel.
12.1 Cleaning the balls
From time to time you may need to clean the balls and the trackerball unit that holds
them.
To do this first unplug the panel and remove the ball.
Clean the ball with a soft damp cloth. Then rub the ball between your hands – this
deposits natural oils from your skin on to the surface of the ball which will help it to run
smoothly.
To clean inside the trackerball unit use a damp cotton bud, paying close attention to the
three white balls the red ball sits on, and the lens which houses the optical sensor. Do
not try and remove the lens and do not press too hard on it. Be gentle and do not have
too much water on the cotton bud – it just needs to be slightly damp.
13.
Firmware updates
The firmware in your Ripple panel was the most up to date version when your panel
was manufactured. It is possible however that a newer version may be available from
our website www.tangentwave.co.uk.
Check your panel firmware version with what is on the website.
Your version is on the serial number label on the bottom of the panel. Look for the
number after “f/w: “.
Make sure you follow the firmware update instructions that come with the update.
