Note: An adjustable wrench may be used instead of an open end wrench.
Installation of Side Mount Mixer (No.1) B-2740
1. Shut off water supply and drain lines. Drill a hole approximately 1-1/2” diameter
in countertop where installing no.1 (side mount body).
2. Take no.1 (side mount body) and no.2 (mounting ring) (see note) and place
no.2 (mounting ring) on top of counter over 1-1/2” diameter hole. Place hoses
of no.1 (side mount body) through hole and place no.1 (side mount body) into
no.2 (mounting ring).
Note: No.3 (mounting o-ring) should be installed in no.2
(mounting ring).
3. From below counter, thread no.4 (threaded locking rod) into hole in bottom of
no.1 (side mount body).
4. Install no.6 (locking c-ring) and then no.5 (brass lock nut) onto no.4 (threaded
locking ring). Hex of no.5 (brass lock nut) should be at bottom for ease of
installation. Tighten no.5 (brass lock nut) with a 3/8” wrench until no.6 (locking c-
ring) is snug against underside of countertop. Note that no.5 (brass lock nut) and
no.6 (locking c-ring) can adjust to counter thickness up to two inches.
5. Connect fl exible supply lines (3/8” female compressions) to water supply. Note
stickers on supply lines, with red sticker indicating hot and blue sticker cold.
Installation of Gooseneck Assembly, included in B-2741, B-2742 &
B-2746 Assemblies:
1. With water supply and drain lines shut off from step 1 above, drill a 7/8”
diameter hole in countertop where no.8 (center body assembly) is to be installed.
The hole should be no more than 6” maximum from center of hole for side mount
mixer in step 1. For rigid gooseneck assembly, no.8 (center body assembly) and
no.7 (gooseneck) are one assembly. For the swivel gooseneck assembly, no.8
(center body assembly) and no.7 (gooseneck) are separate assemblies.
2. Remove no.11 (nut) and no.10 (washer) before placing no.9 (center body shank)
of no.8 (center body assembly) through hole above countertop. After installing
no.8 (center body assembly) in 7/8” diameter hole, put no.10 (washer) and no.11
(nut) back on no.9 (center body shank) below countertop and tighten with 1”
wrench until tight with countertop.
3. Connect outlet hose from side mount mixer to inlet of no.9 (center body
shank). Tighten sung with 15/16” wrench.
4.
FOR SWIVEL ONLY:
Install no.7 (gooseneck) by screwing nut of no.7 (gooseneck)
onto top of no.9 (center body shank). Install grease from packet on swivel o-ring
prior to screwing on no.9 (center body shank). Tighten with 1-1/8” wrench.
5. Open water supply and check for leaks. Lift handle on side mount mixer and
check for leaks.
5
General Instructions
