General Instructions
Installation:
1. Turn off water supply and drain lines. Drill a hole approximately 7/8” (22mm)
diameter in sink or countertop where you are installing no.
1
.
2. Loosen no
.
6
with a wrench and
remove no.
6
, no.
5
, no.
4
, and no.
3
from
threaded end of no.
2
.
3. Place no.
2
through hole in sink or
countertop. Reinstall no.
3
, no.
4
, no.
5
and no.
6
onto no.
2
. Tighten no.
5
against
bottom of sink or countertop
with a wrench.
4. Apply teflon tape or pipe joint
compound to threaded end of no.
2
,
connect cold water supply inlet
to no.
2
. Or use no.
6
if compression
fitting is used.
5. Turn on water supply
and check for leaks.
Adjustment:
Volume control
6. To adjust height of water flow,
rotate no.
7
on bottom side of no.
10
using a 3/32” hex wrench (do not
remove).
7. To raise height of water, turn no.
7
counterclockwise. To lower flow of
water, turn no.
7
clockwise.
Note: The valve index is vandal-resistant. A #8 spanner driver is required to
service the valve assembly (available as T&S part no.BL-5707-05).
4
1
2
3
5
4
1
7
sink or
countertop
5
2
water inlet
see note
6
3
4
6
