PAGE 51/58
119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08
TANDBERG
Telepresence T3
6.
While holding the
Cable well
, thread the audio, VGA and ethernet cables into
the opening of the well. Fasten the cables with the cable clamp so that appr.
80cm of the cables are left outside.
7.
Sink the cable wells onto the premounted screws. Fasten the screws and
close the lid. If the lid is not flush with the table top, loosen the screws and
adjust the cable wells. Then fasten the screws again.
mountinG thE
CollAborAtion sCrEEns
tip!
See the cabling diagram on page 39
and onwards for details on the cabling.
note!
The power cable supplied
with the system is terminated with a
standard IEC connector. An approved
cable with a country-specific connector
will be supplied later. If you source
such cables locally, make sure they are
approved!
