PAGE 14/58
119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08
TANDBERG
Telepresence T3
1.
Unpack the left system and take out the left
Bottom module
. Dismount the
top screw on the right side in addition to the cable hatch cover.
2.
The following cables must be disconnected and removed:
•
112083 Ethernet Cable
•
112980 Power Cable (main in)
•
115233 PC Connection Cable (Video/audio in)
•
117083 Main Speaker Cable (top of amplifier)
•
117087 D-sub Monitor Control Cable (USB-DSUB)
•
118315 External Microphone Cable
•
117084 Audio RCA Cable (Codec to amplifier).
3.
Fasten by fastening 4 × nuts (b).
bottom modulEs
4 × nut (b) M8
tip!
The procedure outlined in this chapter
suggests that you mount all three bottom
modules before you mount the monitors
on top of these modules.
As an alternative, you may prefer to
mount each bottom module / monitor set
completely before proceeding to the next
bottom module / monitor.
Caution!
Regardless of the method
preferred, the cables between the DNAM
modules and the monitors must be
connected to the DNAM modules before
you mount the monitors.
The cables are:
Cable 117850 to the left dnAm
Cable 117852 to the center dnAm
Cable 117856 to the right dnAm
note!
Retain the DVI to HDMI cable
between monitor and codec plus three
power cables.
