9
English
Attach the protection tube to the drive shaft or handle
using cord clamps (8). (Fig. 5)
8
Fig. 5
NOTE
If the protection tube is set apart from the handle
or pipe, it will be caught by something during
operation and it may cause serious injury. Do not
set the protection tube apart from the handle or
pipe.
Throttle
wire
/
stop
cord
Press the upper tab (9) and open the air cleaner
cover. (Fig. 6)
9
Fig. 6
Connect stop cords. (Fig. 7)
Fig. 7
If the throttle outer end (10) is threaded on your unit,
screw it and the earth terminal (11) (if so equipped)
into the cable adjuster stay (12) all the way, and then
tighten this cable end using the adjuster nut (13)
against the cable adjuster stay (12).
Connect throttle wire end (14) to carburetor (15)
and install swivel cap (16) (if so equipped) where is
included in tool bag, onto swivel (15) (Fig. 8).
Some models may come with the parts installed.
11
12
10
13
14
15
16
Fig. 8
Installation
of
blade
guard
(Fig.
9,
10,
10-1,
11)
WARNING
●
Do
not
start
or
operate
unit
unless
each
guard
is
properly
assembled
to
unit.
●
lf
unit
is
operated
without
a
sharp
line
limiters,
the
line
will
become
too
long,
the
engine
will
overheat,
and
engine
damage
may
occur.
●
Check
sharp
line
limiters
surely
cut
nylon
line
when
operating.
Fig. 9
Fig. 10 Fig. 10-1
000Book̲TCG22EAS̲US.indb 9
000Book̲TCG22EAS̲US.indb 9
2012/07/11 16:42:42
2012/07/11 16:42:42
