T A N . S C R E E N
There are 3 x Screen sections
that make up the final
Tan.Screen. This is labeled on
each box (Outer Carton)
Each screen section is to be
assembled in order A (Bottom
Piece)-B (Middle) and then
C(Top Piece).
TIP: There are two sides of the
screen. The back contains the
seal. The seal is located around
the black panel. Make sure this
side faces to the back.
REFER TO DIAGRAM:
1. To begin, open the package
and position the Tan.Screen
in your salon or space.
Allow for the necessary
room around the unit for
free movement and enough
room at the back of the
screen to get access to.
2. Start with Screen Section A.
Place Screen Section B
onto Screen Section A.
Each section simply stacks
on top of each other by the
metal posts.
3. Simply slot Section B into
A.
4. Slot Section C in B.
Each section simply slots into one another as shown below. The Aluminum Frame will be level and secure in place.
Please note: No screwing or tightening is needed. If the panels are not level and fit in place, please refer to Page 7 of this
manual ASSEMBLY: ALUMINUM FRAME: CHANGING THE PANELS & LEVELING OUT THE ALUMINUM FRAME.
SLOTTING EACH SCREEN PANEL TOGETHER:
SECURED IN PLACE:
ASSEMBLY: TAN SCREEN
