PhoneControl
English
Seite 7
Control instructions for locomotive and function decoders
1
Reduce the speed level by one level
2
Change the direction of travel
3
Increase the speed level by one level
4
Reduce the speed level by four levels
5
not used
6
Increase the speed level by four levels
7
Corresponds to button go
8
not used
9
Corresponds to button stop
* and afterwards 1
Switch a function, in this example function f1. In oder to switch the
functions f0 and f2 to f8 enter the corresponding number instead of "1".
* and afterwards #
Accesses the previously selected locomotive. This function allows to
switch easily and quickly between two locomotive addresses you want
to control simultaneously.
Switching instructions for points and switching decoders
# and afterwards 87 Select the adress of a points or switching decoder, example: address 87
afterwards #
Points direction “straight on” or switching decoder output “on”
or afterwards *
Points direction “branching” or switching decoder output “off”
Special features
The hand set allows you to call existing double tractions and to enter control instructions for the
first locomotive in a double traction. You can also cancel existing double tractions but it is not
possible to create a double traction with the hand set
In order to lock an address you have to enter the locomotive address twice – exactly the same
way as with the Master or the LokControl. To make these entries you have to go back to the
selection mode after you have entered the address for the first time and enter the address again.
