English
PhoneControl
Seite 6
5. PhoneControl Operation
When the hand set is connected with the EasyNet you can:
§
select addresses of locomotive and function decoders,
§
enter control instructions for locomotive and function decoders and
§
enter switching instructions for points and switching decoders.
Unlike the external control device LokControl, you cannot read or alter data from the locomotive
database of the connected MasterControl or alter configuration variables of locomotive and
function decoders for the DCC format via maintrack programming.
Please note:
Before entering instructions you first should switch on the hand set. Many cordless
telephones can be preset to automatic switching on as soon as the hand set is taken out off the
docking station.
Display
The PhoneControl is available with display as well as without display. Devices with display show
the last called decoder address, the locomotive’s name (if set), the corresponding data format, the
set speed level, the driving direction and the switched-on functions. The display shows as well, if
an active locomotive is accessable or not for other control units.
Selection mode
In the selection mode you can select the addresses of locomotive or function decoders you want
to enter control instruction for, or make a reset of the PhoneControl. In order to access the
selection push:
0 and afterwards *
In the selection mode there are the following possibilities:
99 and afterwards # Select a locomotive adress, example: address 99. After pushing # the
PhoneControl switches automatically to the control mode.
*
Delete input
8 times *
Reset the EasyControl. After a reset the PhoneControl switches
automatically to the control mode.
Control mode
In the control mode you can enter control instructions for locomotive and function decoders and
switching instructions for points and switching decoders. After having switched on the layout,
after a reset released by the PhoneControl or after having selected a locomotive address the
PhoneControl switches automatically to the control mode. To switch directly from the selection
mode to the control mode push:
0 and afterwards #
