Installing the GPIO Interface
This section explains how to install the TAMS 61622 GPIO interface in the
computer. To complete the installation:
1.
Make sure the computer power switch is off.
2.
Refer to the Owner’s Guide of your computer for instructions on opening
your computer and installing PCI boards.
3.
Install the GPIO interface in the PC by plugging the card into the PCI slot.
Make sure that the card is firmly seated in the slot.
Follow the instructions being careful to handle the TAMS 61622 board only
by its metal bracket. Avoid contact with the edges. After the board has been
plugged in and the retaining screw installed the computer should be
reassembled.
4.
Prepare and install the GPIO interface cable.
Note:
The TAMS 61622 is a PCI device. Unlike most EISA and ISA devices a
PCI device does not require an I/O address or IRQ setting. These settings are
handled automatically.
6
