ADJUSTING THE TEMPERATURE & SPEED
1. Turn off the “BOTTOM ROLLER HEATER” switch on the right side of machine.
2. Press the “U” key and the digital screen display will show the previous temperature setting of upper
roller. Adjust the upper roller temperature by pressing the “TEMP/SET” “
︿
” or “
﹀
” arrow keys and
the digital screen display will beep showing the set temperature for 3 seconds before showing the
actual machine temperature.
3. Once the temperature is set, press the “HOT” key to start the heating process and the heater light will
turn on. Once the set temperature is achieved and roller temperature is stabilized, the machine will
start beeping and the ready light will turn on. Once the ready light stays on, you can set the
recommended speed.
4. Press the “MOTOR” “
︿
” or “
﹀
” arrow keys to set the motor speed. The following table gives a
common temperature/speed setting for typical use.
Nylon Film Thickness
Temperature
Speed
0.5 Mil(12 Micron)
100°C(212°F)
3 ~ 4
5. Turn on the rear fans to prevent film from bunching in the back of the machine.
LAMINATING PROCEDURES
1. Align the material to be laminated evenly onto the mounting board before feeding it in.
2. Push the handle to the “DOWN” position to engage the rollers. The user can now start laminating
as the machine starts feeding in film.
3. Make sure the film does not wrap around the back roller before the first board is out by pulling on the
film from the back until the board comes out a few inches.
4. To put the lamination temporarily on hold without turning off the machine, user can turn the motor
control switch found on the right side panel to “STOP” position. This will cause the motor to stop
running and the film will stop feeding.
5. To resume the lamination job, turn the switch to the “RUN” position again
6. For laminating with mounting, feed more film as soon as the last board is fed until it is all the way
out.
7. When done lamination, turn the motor control switch to “STOP” position, then trim the film using
the included slitter.
