8
I. MOUNTING FUNCTION
1. The user can choose to mount prints or posters using up to 1/4” thick foam boards.
a. For mounting and encapsulating using thermal film, simply set the machine up for
2-SIDED
LAMINATION
. Line up the material evenly on a standard foam board and set the temperature
of
the machine.
b. For simultaneous mounting with 1-sided lamination using nylon, BOPP or even thermal film, set
the machine up for
1-SIDED LAMINATION
without raising the middle de-curling bar. Turn the
bottom roller heater switch to OFF position. Adjust the temperature based on the thickness of the
top roller film and make sure the print is properly aligned onto the board.
c. For mounting without any film threaded on the machine using either pouch boards or foam boards
with heat activated adhesives, simply align the print evenly onto the board. The operating
procedure for adjusting heat and speed for this function is the same as the procedures for
laminating function. Please consult pouch board supplier for ideal activation temperature of their
adhesives.
d. For cold mounting only using self stick boards that have liners, care and precision must be
exercised as this has a tendency to produce wrinkles and/or uneven positioning when the print is
not properly set.
There is no need for film to be threaded onto the machine and it is recommended
to set temperature at 50°C (122°F) on the top roller for best results.
Simply remove the liner from
the board, carefully and evenly align the print and set it onto the adhesive side. The pressure
applied by the rollers will enhance adhesion of the print onto the board.
Please refer to
instructions on how to apply prints on these types of boards that come with their packaging
or consult with the mounting board supplier.
2. Once the machine is hot enough and ready to laminate,
push the handle to DOWN position and
motor switch should be in RUN position.
3. Feed materials between the engaged rollers.
4. Put the motor switch in STOP position to stop the feeding when the board is all the way out in the
back.
MOUNTING WITHOUT LAMINATION
