5
ADJUSTING THE TEMPERATURE & SPEED
1.
Turn on the power switch and make sure to turn off the “BOTTOM ROLLER HEATER” switch on the
right side of machine.
2.
Press the “U” key and the digital screen display will show the previous temperature setting of upper
roller. Adjust the upper roller temperature by pressing the “TEMP/SET” “
︿
” or “
﹀
” arrow keys and
the digital screen display will beep showing the set temperature for 3 seconds before showing the
actual machine temperature.
3. Once the temperature is set, press the “HOT” key to start the heating process and the heater light will
turn on. Once the set temperature is achieved and roller temperature is stabilized, the machine will start
beeping and the ready light will turn on. Once the ready light stays on, you can set the recommended
speed.
4. Press the “MOTOR” “
︿
” or “
﹀
” arrow keys to set the motor speed. The following table gives a
common temperature/speed setting for typical use.
Nylon Film Thickness
Temperature
Speed
0.5Mil (12 Micron)
100°C(212°F)
3 ~ 4
5. Turn on the rear fans to prevent film from bunching in the back of the machine.
LAMINATING PROCEDURES
1. Push the handle to “DOWN” position to engage the rollers and then turn the motor switch to
“RUN” position .The user can now start laminating as the machine starts feeding in film.
