TP-50BS (Rev 1.0)
- 16 -
TALON TECH CO. LTD.
6-1-6 Configuration of Pump
On Config Pump, the password needs for the important items’ set.
Vital
-
Check pump’s response and in case of response, ‘vital’
window activates and disappears right away. At the left window,
the response data is shown.
Error Status
-
Shown Error Code Data.
Set ID
-
Change Pump ID.
[Discuss with Talon Tech]
Maint Mode
-
Change Pump Mode to Maint.
Run Mode
-
Change Pump Mode to Run
Pump Reset
-
Reset Pump. It means Pump Restart, not Data Reset.
Error Mark
-
Stop Error Setting.
[Discuss with Talon Tech]
6-1-6-1 ID Setting
ID changes without any discussion could make the controller error. It is much better to ask Talon
Tech.
6-1-6-2 Maint Mode, Run Mode, Pump Reset Setting
Main Mode is to show the message of pump operation on the text window. Run Mode only
shows as data code. The setting method is to touch Maint Mode, Run Mode button and input
password and touch ‘Ent’. In case of no response from pump, message of mode keeps showing.
Pump reset works right after input password. It goes to the initial screen same as power off and
on. It takes about 20sec.
6-1-7 Calibration
