TallyGenicom T2265, Maintenance Manual

Page: 175 / 190

Specifications Cutting Device (Option)
11-1
11 Cutting Device (Option)
11.1
Specifications
For all further data and specifications, please refer to your printer’s standard opera-
tor’s manual or the operator’s manual “Cutting Device”.
Safety notes:
– If you have any short pieces of paper remaining in the device, turn off the
printer first.
– Do not stick unsuitable materials or tools – such as screw drivers etc. – into the
device openings as this may damage the mechanical system.
– Replace the protective cap for the drive wheel at the printer when the cutter is
no longer needed (in use) to prevent long hair, chains etc. from being pulled into
the printer.
Cut width
Cut height
Cut time
Specification of
recommende forms
Cutting accuracy
Service life
Weight
Paper type
Paper weight
Copies
Stacker
400 mm
min. form length 2.5 inches (6.35 cm)
1000 ms ±10%
Only continous forms in printer tractors can be cut
Single forms and two part forms ±1 mm
Other forms ±2 mm
depending on the stiffness of the cross perforation
>1.000.000 cuts
approx. 4 kp
fanfold paper
Single form: 60 g/m
2
– 120 g/m
2
Multi-part form (Main tractor):
Original
45 g/m
2
– 120 g/m
2
1st sheet 45 g/m
2
– 65 g/m
2
Copies 45 g/m
2
– 56 g/m
2
Last sheet 45 g/m
2
– 65 g/m
2
Total <280 g/m2
Multi-part form (Rear tractor):
1st sheet 45 g/m
2
– 65 g/m
2
1st copy 45 g/m
2
– 56 g/m
2
2nd copy 45 g/m
2
– 56 g/m
2
1 + 6
1 sheet-sets 150 sheets 80 g/m
2
6 sheet-sets 50 sets
multi-part depends on crimping (punch printing on edge
of sheet) and perforation/paper weight
Paper stacking, above all of multi-part sets, depends on
the quality of the crimping